DIY How to repair a broken magnet on a WerkMaster Plug N' Go Plate

Learn how to repair a magnet on a Werkmaster Plug N' Go tooling plate.

Step 1: Remove any debris or residual glue from the plate
Step 2: Remove any debris or glue from the magnet
Step 3: Use lacquer thinner to prepare for glue
Step 4: Apply Loctite SF7387 Activator to the magnet slot
Step 5: Apply Loctite AA332 adhesive to the magnet slot
Step 6: Install the magnet into the magnet slot and clean thoroughly

Important note: Glue drying time is 30 minutes for 50% strength, 3 hours for 90% strength